HP P4459A, Руководство по установке и эксплуатации

Страница: 24 / 72

16
HP P4459A 8-Port Fibre Loop Switch Installation & Operation Guide
• Step 4: Attach the Sleeves to the Front Rack Columns
• Step 5: Attach the Switch Rails to the Switch Chassis
• Step 6: Install the Switch
• Step 7: Complete the Installation
Step 1: Preparation
Before you install the switch into an HP rack, refer to the rack documentation as
you extend the anti-tip foot or ensure that the anti-tip feature is installed. Lower
the leveler feet.
Use the original ordering information to locate where each component goes in the
rack. If the original ordering information is not available, use the HP Rack
Assistant software to determine where to mount the switch in the rack.
Use tape or a marker pen to mark the bottom of the single EIA unit required by
the switch. For EIA unit boundaries, refer to Figure 7 and Figure 8.
Caution: Do the following to prevent the rack enclosure from tipping
over. Failure to take these precautions could result in serious injury and
equipment damage.
•
Extend the anti-tip foot, or verify that the anti-tip feature is installed.
• Verify that the leveler feet are lowered.
• Do NOT extend more than one piece of equipment at a time out from
the front of the rack.