Symptom
Possible solution
I cannot connect to
the Internet.
For Windows 7:
1.
Click
Start
, click
Control Panel
, click
Action Center
, and then click
Troubleshooting
.
2.
Under
Network and Internet
, click
Connect to the Internet
.
Verify that you are using the proper cables for your Internet connection type. Your
computer might have a dial-up modem and an Ethernet network adapter (also called a
network interface card, or NIC). A modem uses a standard telephone cable, whereas the
network adapter uses a network cable, to connect to a local area network (LAN). Do not
connect a telephone cable to the network adapter, and do not plug a network cable into a
telephone service line; doing so might damage the network adapter.
Run the
wireless setup wizard
:
1.
Click
Start
, click
Control Panel
, click
Network and Internet
, and then click
Network and Sharing Center
.
2.
In the
Network and Sharing Center
window, click
Set up a connection or
network
to open the wizard, and then follow the on-screen instructions.
If your system has an external antenna, try to move the antenna to a better position. If the
antenna is internal, try to move the computer.
Try to connect again later, or contact your Internet service provider (ISP) for assistance.
Software troubleshooting
To repair
software
problems, try
these methods:
●
Turn the computer off completely and then turn it on again. This is the easiest (and
sometimes the best) way.
●
Update the drivers (see Updating device drivers, following).
●
Use Microsoft System Restore Software program and hardware driver reinstallation (see
Microsoft System Restore, later in this table). — Restores your computer to a configuration
that was in use before the software was installed.
●
Reinstall the software program or hardware driver (see Software program and hardware
driver reinstallation, later in this table). — Restores the software (if it came with the
product) or hardware driver to factory defaults.
●
System Recovery (see
Troubleshooting and Maintenance Guide
on your computer. At the
bottom of your screen, click on
Start
, then click
HP Help and Support
and
HP User
Manuals
. ) — Erase and reformat the hard disk drive, and then reinstall the operating
system, programs, and drivers. This erases all data files you have created.
Software troubleshooting
15
Содержание Omni 27-1100
Страница 1: ...12 30cm ...
Страница 2: ...http www hp com go contactHP http welcome hp com country us en wwcontact_us html ...
Страница 4: ......