Installing Hardware Options
3-2
HP ProLiant ML530 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: d-ch3 Installing Hardware Options.doc
Codename: Seattle Slew Part Number: 225579-002 Last Saved On: 1/8/03 3:00 PM
The following warnings apply to all procedures:
WARNING: The server is very heavy, up to 66 kg (146 lb). To reduce
the risk of personal injury or damage to the equipment:
•
Remove all hot-plug power supplies to reduce the weight of the
server before lifting it.
•
Observe local occupational health and safety requirements and
guidelines for material handling.
•
Get help to lift and maneuver the server.
•
Be sure the server casters are locked in place on tower models.
WARNING: To reduce the risk of personal injury or damage to the equipment:
•
Heed all warnings and cautions throughout the installation instructions.
•
Allow internal system components to cool before touching any surfaces.
•
Be sure that the power to the server is turned off and that all power cords
are disconnected.
•
Allow only qualified service personnel—those trained to work with
products capable of producing hazardous energy levels—to install options,
except when installing hot-plug power supplies or hard drives.
CAUTION:
Electrostatic discharge can damage electronic components. Be sure you
are properly grounded before beginning any installation procedures.
The following warnings apply to in-rack operations only:
WARNING: Always begin by mounting the heaviest item on the bottom of the
rack. Continue to populate the rack from the bottom to the top.
WARNING: To reduce the risk of personal injury or equipment damage, always
be sure that the rack is adequately stabilized before extending a component
outside the rack. A rack may become unstable if more than one component is
extended for any reason. Extend only one component at a time.
