This package contains one maintenance kit
(Q5421A 110 V kit or Q5422A 220 V kit)
consisting of one fuser, one transfer roller,
one plastic transfer-roller tool, one pickup
roller, eight feed rollers, and one pair of
disposable gloves. The cost of this kit is not
covered under the original printer warranty or
under most extended warranties.
NOTE
Depending upon which optional
accessories are installed, you might not need
all of the feed rollers included in this kit.
Disconnect all cables from the rear of the
printer.
NOTE
There might be additional cables
connected to the printer that are not shown
below. Make sure that you disconnect
all
of
the cables from the rear of the printer.
Before installing the maintenance kit:
CAUTION
When replacing the fuser, the
printer
must
be turned off for 30 minutes to
allow the fuser to cool down.
Turn the printer power off.
To replace the transfer roller:
CAUTION
Never expose the print cartridge
to bright direct light. Cover the print cartridge
when it is removed from the printer to
prevent the cartridge from being damaged.
Open the top cover and remove the print
cartridge. Locate the transfer roller beneath
the area from which the print cartridge was
removed.
Turn the printer so that its rear cover faces
you. Lift and pull to remove the optional
duplexer, if it is installed.
CAUTION
Do not lift the left end of the
transfer roller too far when removing the
transfer roller.
Use the plastic transfer-roller tool (callout 1)
to
slightly
lift the left end of the metal shaft
upward (callout 2). Slide the transfer roller to
the left and remove it (callout 3).
En
glish
English
3
