6.
Run the command “
no module <slot>
” to switch configuration, if you are exchanging
one type of module with a different type of module in the same slot.
7.
Issue the “
reload module x
” command, where x is the letter of the slot (A through L).
The following warning will be displayed:
WARNING!
The
reload module
command will shut down the specified modules and
ports on those modules will not send or receive packets while the module is down. Any
management traffic for the switch passing through the affected modules will be interrupted,
including SSH, TELNET, and SNMP. It may take up to 2 minutes to completely reload the
modules. During that time, you can monitor progress by viewing the event log.
Continue (y/n)?
8.
Enter ‘y’ to proceed with the swap. It will take a few seconds for the module to become
operational.
21
