Replacing the MegaRAID iTBBU02 Battery
CA293-04780
rev 00
page 8 of 10
Test procedure
1.
Turn on the core server.
2.
After completion of the power-up sequence, log in using the Unicorn account.
3. Select
Start
and
Run
.
4. Type
cmd
and click
OK
. The
Command Prompt
window appears.
5.
At the DOS prompt, type
megacli –AdpBbuCmd –GetBbuStatus –a0
and press
Enter
.
6. Examine
the
Command Prompt
window:
•
If the above information appears, the battery is connected properly.
•
If “Invalid input" appears, check the spelling of the command in step 5.
•
If a blank line appears, the battery is not connected properly. Perform the procedure
again.
