HP HPE 3PAR StoreServ 8000, Руководство по установке

Страница: 59 / 152

6 System Component Installation in Existing Rack
This chapter describes the procedures for installing system components in an existing rack.
Before you set up a system, ensure that all requirements documented in the
HPE 3PAR StoreServ
8000 Storage Site Planning Manual have been met.
To set up a system delivered in a fully loaded Hewlett Packard Enterprise cabinet, see “Hewlett
Packard Enterprise Factory-Integrated System Setup” (page 55) .
Unpacking Enclosures
CAUTION: Enclosures are heavy. Two people are required for lifting, moving, or installing an
enclosure.
To unpack an enclosure:
1.
Cut open the cardboard box and remove the top.
2. Remove the rail kit.
3. Remove the packing foam around the enclosure.
4. Remove the enclosure from the box.
Rail Kit Installation
Before you install an enclosure in the rack, first mount the two rail shelves to the rack.
NOTE: To mount a one unit (1U) rail shelf (used for installing an SP) to the rack, follow the
installation instructions included with that SP 1U mounting kit.
Table 24 (page 59) lists the rail kit part numbers for each type of installation.
Table 24 Rail kit part numbers
Rail Kit Assembly 4U Enclosure Rail Kit Assembly 2U Enclosure
PN 793951-001 PN 793950-001
NOTE: For more information about the rail kit assembly, see “Rail Kits” (page 119) .
The rail kit contains two rails, two middle support brackets, and T25 Torx screws. The rail channels
are mounted to the inside of the rack using two shoulder screws at each end of the rack (four
screws per rail), and a middle support bracket for mounting between the adjustable rails. Installing
the middle support bracket applies only to the 2U and 4U enclosures. The front labels read
FRONT RIGHT and FRONT LEFT with an arrow pointing in the front direction.
Unpacking Enclosures 59