111
To remove the chassis from the rack:
1.
Prepare the wooden pallet base, carton, and packing bag of the chassis. Make sure they are clean,
dry, and not damaged.
2.
Put the wooden pallet base to a proper place.
3.
As shown in callout 1 in
, use a Phillips screwdriver to loosen the screws that attach the
mounting brackets to the rack.
4.
As shown in callout 2 in
, use at least four persons to slide the chassis outwards along the
slide rails. When most part of the chassis is removed from the slide rails, lift up the chassis by
holding the handles at the chassis sides to completely remove the chassis from the rack.
5.
Put the chassis onto the wooden pallet base.
Figure 81
Removing the chassis from the rack
(1) Loosen the captive screws that attach the mounting brackets to the rack
(2) Slide the chassis outwards along the slide rails
Removing the power cable bracket
Before you repack the 12910 AC switch, remove the power cable bracket. The power cable bracket of the
12910 AC is attached to the power distribution box on the rear panel.
To remove the power cable bracket:
1.
Prepare the packing bag and box of the power cable bracket. Make sure they are clean, dry, and
not damaged.
2.
Use a screwdriver to loosen the screws that attach the power cable bracket to the chassis and
remove the power cable bracket from the chassis.
Содержание FlexFabric 12900 series
Страница 13: ...7 Figure 2 Clearances required for a 12910 AC chassis ...
Страница 108: ...102 Figure 73 Example of a device label ...
