HP FlexFabric 12500E, Руководство по установке

Страница: 71 / 141

65
1 6 ERROR Power 2 is absent.
1 6 ERROR The board in slot 10 is faulty.
2 3 WARNING The temperature of sensor 3 exceeds the lower limit.
Table 18 Command output
Field Description
Chassis
ID of the IRF member switch with an alarm.
If the value is a hyphen (-), the alarm was generated by the chassis.
Slot Number of the slot where the card resides.
Level
Alarm severity. Possible values include ERROR, WARNING, NOTICE,
and INFO, in descending order.
Info Detailed alarm information.
The board in slot n is faulty. The card in slot n is starting up or faulty.
Verifying and diagnosing transceiver modules
At present, there are three types of commonly used transceivers, as shown in Table 19 . They can be
further divided into optical transceivers and electrical transceivers based on transmission medium.
Table 19 Commonly used transceivers
Transceiver type Application scenarios
Whether
can be an
optical
transceiver
Whether
can be an
electrical
transceiver
SFP (Small Form-factor Pluggable)
Generally used for 100M/1000M
Ethernet interfaces or POS
155M/622M/2.5G interfaces
Yes Yes
SFP+ (Enhanced 8.5 and 10 Gigabit
Small Form-factor Pluggable) Generally used for 10G Ethernet
interfaces
Yes Yes
XFP (10-Gigabit small Form-factor
Pluggable) Generally used for 10G Ethernet
interfaces
Yes No
Verifying transceiver modules
You can verify the genuineness of a transceiver module in the following ways:
•
Display the key parameters of a transceiver module, including its transceiver type, connector type,
central wavelength of the transmit laser, transfer distance and vendor name.
• Display its electronic label. The electronic label is a profile of the transceiver module and contains
the permanent configuration including the serial number, manufacturing date, and vendor name.
The data is written to the storage component during debugging or testing.
To verify transceiver modules, execute the following command in any view: