HP FlexFabric 11908-V, Руководство по установке

Страница: 34 / 114

28
Figure 23 Connecting the power cable
(1) Insert the power cable plug into the power supply. (2) Fasten the screw.
3. (Optional.) Use a cable tie to secure the power cable to the cable management bracket. For more
information, see
Figure 22 .
4. Connect one end of the blue DC power cable marked with –48V to the negative terminal (–48V)
on the power source and the RTN end of the black DC power cable to the positive terminal (RTN).
Installing a transceiver module (optional)
CAUTION:
•
To avoid component damage, read this section carefully before installing a transceiver module.
• Do not remove the protection cover from a transceiver module before connecting an optical fiber.
• Remove the optical fiber, if any, from a transceiver module before installing it.
The transceiver modules available for the switch include SFP, SFP+, and QSFP+.
Installing an SFP+/SFP/QSFP+ module
1. Wear an ESD wrist strap and make sure it makes good skin contact and is well grounded. For
more information, see " Attaching an ESD wrist strap ."
2. Unpack the module. Do not touch the golden finger of the module.
3.
Pivot the clasp of the module up. Holding the module, gently push the module into the slot until it
has firm contact with the slot (when the top and bottom spring tabs catch in the slot), as shown
in Figure 24 .
{
For a QSFP+ module that uses a plastic pull latch, skip this step. QSFP+ modules use either a
metal or plastic pull latch. They are installed in the same way except that you must pivot the
clasp up for the module that uses a metal pull latch.
{
For an SFP+ module, press the module down against the upward force of the bottom spring tab
so you can push the module straight into the port.
{
If you cannot hold the module by its two sides because of high module density, press the module
on its head end to push it in.