HP EliteOne 1000 G1, Справочник по аппаратуре

Страница: 31 / 37

IMPORTANT: Regardless of the power-on state, voltage is always present on the system board as long
as the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
computer.
4. Insert a paper clip into the release holes on each side of the webcam (1) to disengage the internal
latches, and then pull the webcam out of the display head (2).
5. Insert the new webcam into the webcam slot on the display head and press the webcam down so that it
engages the internal latches.
6. Reconnect the power cord and any external devices, and then turn on the computer.
To install a webcam when a webcam blank is installed in the webcam slot on the display head:
1. Remove all removable media, such as USB flash drives, from the computer.
2. Turn off the computer properly through the operating system, and turn off any external devices.
3. Disconnect the power cord from the AC outlet and disconnect any external devices.
IMPORTANT: Regardless of the power-on state, voltage is always present on the system board as long
as the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
computer.
Replacing or installing a webcam 25