HP Edgeline EL1000, Руководство пользователя

Страница: 87 / 164

Using iLO 5 configuration utility Using iLO 5 configuration utility
This step is required only if you want to use a static IP address. When you use dynamic IP addressing, the DHCP serverautomatically
assigns an IP address for iLO.
To simplify installation, Hewlett Packard Enterprise recommends using DNS or DHCP with iLO.
Procedure Procedure
1. (Optional) If you access the server remotely, start an iLO remote console session.
2. Restart or power on the server.
3. Press F9 in the server POST screen.
The UEFI System Utilities start.
4. Click System Configuration.
5. Click iLO 5 Configuration Utility.
6. Disable DHCP:
a. Click Network Options.
b. Select OFF in the DHCP Enable menu.
The IP Address IP Address, Subnet Mask Subnet Mask, and Gateway IP Address Gateway IP Address boxes become editable. When DHCP Enable DHCP Enable is set to ON ON, you cannot edit
these values.
7. Enter values in the IP Address, Subnet Mask, and Gateway IP Address boxes.
8. To save the changes and exit, press F12 F12.
The iLO 5 Configuration Utility prompts you to confirm that you want to save the pending configuration changes.
9. To save and exit, click Yes - Save Changes Yes - Save Changes .
The iLO 5 Configuration Utility notifies you that iLO must be reset in order for the changes to take effect.
10. Click OK OK.
iLO resets, and the iLO session is automatically ended. You can reconnect in approximately 30 seconds.
11. Resume the normal boot process:
a. Start the iLO remote console.
The iLO 5 Configuration Utility is still open from the previous session.
b. Press ESC ESC several times to navigate to the System Configuration System Configuration page.
c. To exit the System Utilities and resume the normal boot process, click Exit and resume system boot Exit and resume system boot .
Using iLO 5 configuration utility 87