HP E4510-48G, Справочник по командам

Страница: 974 / 1334

1-25
Default Level
3: Manage level
Parameters
None
Description
Use the telnet server enable command to make the switch to operate as a Telnet Server.
Use the undo telnet server enable command disable the switch from operating as a Telnet server.
By default, a switch does not operate as a Telnet server.
Examples
# Make the switch to operate as a Telnet Server.
<Sysname> system-view
[Sysname] telnet server enable
% Start Telnet server
# Disable the switch from operating as a Telnet server.
[Sysname] undo telnet server enable
% Close Telnet server
terminal type
Syntax
terminal type { ansi | vt100 }
undo terminal type
View
User interface view
Default Level
2: System level
Parameters
ansi : Specifies the terminal display type to ANSI.
vt100 : Specifies the terminal display type to VT100.
Description
Use the terminal type command to configure the type of terminal display .
Use the undo terminal type command to restore the default.
Currently, the system support two types of terminal display : ANSI and VT100.
By default, the terminal display type is ANSI. The device must use the same display type as the
terminal. If the terminal uses VT 100, the device should also use VT 100.
Examples
# Set the terminal display type to VTY 100.