HP E4510-48G, Справочник по командам

Страница: 733 / 1334

8-9
By default, no secure MAC address is configured.
Note that:
z
The port must belong to the specified VLAN.
z
You can configure a secure MAC address only if port security is enabled and the specified port
operates in autoLearn mode.
z
The undo port-security mac-address security command can be used in system view only.
Related commands: display port-security .
Examples
# Enable port security, set the port security mode of port GigabitEthernet 1/0/1 to autoLearn, and add a
secure MAC address of 0001-0001-0002 (belonging to VLAN 10) for port GigabitEthernet 1/0/1 in
system view.
<Sysname> system-view
[Sysname] port-security enable
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port-security max-mac-count 100
[Sysname-GigabitEthernet1/0/1] port-security port-mode autolearn
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] port-security mac-address security 0001-0001-0002 interface gigabitethernet 1/0/1
vlan 10
# Enable port security, set the port security mode of port GigabitEthernet 1/0/1 to autoLearn, and add a
secure MAC address of 0001-0002-0003 (belonging to VLAN 4) for port GigabitEthernet 1/0/1 in
interface view.
<Sysname> system-view
[Sysname] port-security enable
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port-security max-mac-count 100
[Sysname-GigabitEthernet1/0/1] port-security port-mode autolearn
[Sysname-GigabitEthernet1/0/1] port-security mac-address security 0001-0002-0003 vlan 4
port-security max-mac-count
Syntax
port-security max-mac-count count-value
undo port-security max-mac-count
View
Ethernet interface view
Default Level
2: System level
Parameters
count-value : Maximum number of secure MAC addresses allowed on the port, ranging 1 to 1,024.