HP E4510-48G, Справочник по командам

Страница: 690 / 1334

3-16
View
HWTACACS scheme view
Default Level
2: System level
Parameters
minutes : Real-time accounting interval in minutes. It is a multiple of 3 in the range 3 to 60 and defaults
to 12.
Description
Use the timer realtime-accounting command to set the real-time accounting interval.
Use the undo timer realtime-accounting command to restore the default.
Note that:
z
For real-time accounting, a NAS must transmit the accounting information of online users to the
HWTACACS accounting server periodically. This command is for setting the interval.
z
The setting of the real-time accounting interval somewhat depends on the performance of the
NAS and the HWTACACS server: a shorter interval requires higher performance. You are
therefore recommended to adopt a longer interval when there are a large number of users (more
than 1000, inclusive). The following table lists the recommended ratios of the interval to the
number of users.
Table 3-2 Recommended ratios of the accounting interval to the number of users
Number of users Real-time accounting interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
1000 or more 15 or more
Examples
# Set the real-time accounting interval to 51 minutes for HWTACACS scheme hwt1 .
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] timer realtime-accounting 51
timer response-timeout (HWTACACS scheme view)
Syntax
timer response-timeout seconds
undo timer response-timeout
View
HWTACACS scheme view