HP E4510-48G, Справочник по командам

Страница: 485 / 1334

6-4
Table 6-1 display route-policy command output description.
Field Description
Route-policy Route policy name
Permit Match mode of route policy node 10
if-match ip-prefix abc Match criterion
apply cost 120 If the match criterion is satisfied, set a cost of 120 for routing information.
if-match cost
Syntax
if-match cost value
undo if-match cost
View
Route policy view
Default Level
2: System level
Parameters
cost : Cost in the range 0 to 4294967295.
Description
Use the if-match cost command to match routing information having the specified cost.
Use the undo if-match cost command to remove the match criterion.
The match criterion is not configured by default.
Related commands: if-match interface , if-match acl , if-match ip-prefix , if-match ip next-hop ,
if-match tag , route-policy , apply ip-address next-hop , apply cost , apply tag .
Examples
# Configure node 10 in permit mode of route policy policy1 : define an if-match clause to permit routing
information with a cost of 8.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match cost 8
if-match interface
Syntax
if-match interface { interface-type interface-number }&<1-16>
undo if-match interface [ interface-type interface-number ]&<1-16>