HP E4510-48G, Справочник по командам

Страница: 131 / 1334

4-19
stp compliance
Syntax
stp compliance { auto | dot1s | legacy }
undo stp compliance
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default Level
2: System level
Parameters
auto : Configures the port(s) to recognize the MSTP BPDU format automatically and accordingly
determine the format of MSTP BPDUs to send.
dot1s : Configures the port(s) to receive and send only standard-format (802.1s-compliant) MSTP
BPDUs.
legacy : Configures the port(s) to receive and send only compatible-format MSTP BPDUs.
Description
Use the stp compliance command to configure the mode the specified port(s) will use to recognize
and send MSTP BPDUs.
Use the undo stp compliance command to restore the system default.
By default, a port automatically recognizes the formats of received MSTP packets and determines the
formats of MSTP packets to be sent based on the recognized formats.
Note that:
z
Configured in Ethernet interface view, the setting takes effect on the current interface only;
configured in port group view, the setting takes effect on all ports in the port group.
z
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate
interface; configured on a member port in an aggregation group, the setting can take effect only
after the port leaves the aggregation group.
Examples
# Configure GigabitEthernet 1/0/1 to receive and send only standard-format (802.1s) MSTP packets.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp compliance dot1s
stp config-digest-snooping
Syntax
stp config-digest-snooping
undo stp config-digest-snooping