HP E3800 Series, Руководство по обеспечению безопасности доступа

Страница: 65 / 732

2-15
Configuring Username and Password Security
Saving Security Credentials in a Config File
802.1X Port-Access Credentials
802.1X authenticator (port-access) credentials can be stored in a
configuration file. 802.1X
authenticator credentials are used by a port to
authenticate supplicants requesting a point-to-point connection to the switch.
802.1X
supplicant credentials are used by the switch to establish a point-to-
point connection to a port on another 802.1X-aware switch. Only 802.1X
authenticator credentials are stored in a configuration file. For information
about how to use 802.1X on the switch both as an authenticator and a
supplicant, see “Configuring Port-Based and Client-Based Access Control
(802.1X)” in this guide.
The local password configured with the password command is no longer
accepted as an 802.1X authenticator credential. A new configuration
command (
password port-access) is introduced to configure the local operator
username and password used as 802.1X authentication credentials for access
to the switch.
The
password port-access
values are now configured separately from the
manager and operator passwords configured with the
password manager
and
password operator
commands and used for management access to the switch.
For information on the new
password
command syntax, see “Password
Command Options” on page 2-13.
After you enter the complete password port-access command syntax, the
password is set. You are not prompted to enter the password a second time.
Encryption Key Authentication
You can use servers to authenticate users who request access to a
switch through Telnet (remote) or console (local) sessions. uses an
authentication hierarchy consisting of:
■ Remote passwords assigned in a server
■ Local manager and operator passwords configured on the switch.
When you configure , the switch first tries to contact a designated
server for authentication services. If the switch fails to connect to
any server, it defaults to its own locally assigned passwords for
authentication control if it has been configured to do so.
For improved security, you can configure a global or server-specific
encryption key that encrypts data in packets transmitted between
a switch and a RADIUS server during authentication sessions. The key
configured on the switch must match the encryption key configured in each