Rev 02
2/3
17 Jan 2006
You first want to turn the power supply on. This is simply done by depressing the power
switch located on the lower left hand corner on the face of the power supply.
Here is how to connect the outputs:
Setting 0 to 6V:
First you want to use the Display Selection switches and press the +6V key. By doing this
you are in 0-6 Volt output mode.
You should see the resulting mode displayed. Next for safety purposes you should press
the Output On/Off button( so that the output is on) to make sure your output is currently
set to 0. You should now see Voltage with corresponding Current displayed. You want to
0 the values out. You do this by using the left/right arrows to select each digit you wish to
change. You can change the digit by using the circular knob and turning it clockwise to
increase the value or turning it counterclockwise to decrease it. After this is done push the
Output On/Off button so that the output is off now.
To get the proper outputs connected you will simply attach the cables to the following
positive/negative posts:
6V
+
–
Red Post= Positive Cable
Black Post= Negative/Ground Cable
