HP E1433A, Руководство пользователя, Страница: 197 / 222

General
Option AYF, Tachometer Input, provides two
tachometer inputs. When this option is installed, 2 of
the 3 SMB connectors on the VXI module are used for
tachometer inputs. When this option is not installed,
these connectors are normally used for “External
Sample” and “Trigger.”
Each tachometer input has a programmable trigger
level. Each tach pulse causes a “Tach Edge Time” to
be recorded in a 16384-word FIFO. A “Tach Edge
Time” is the instantaneous value of the 32-bit “Tach
Counter”. A “Decimate” number can be set to ignore
a number of tach pulses before recording each Tach
Edge Time. A “Holdoff” time can be set to avoid false
triggering due to ringing.
One of the tachometer inputs can be programmed for
use as a trigger input rather than a tachometer input.
In this mode, the tachometer option can trigger the
system and measure the time between the trigger and
the next sample clock edge.
The analog signal from either of the Tachometer
inputs can be routed to an input channel using the
internal calibration path.
Tach Counter
32-bit counter with roll-over detector bit
Decimate Counter
16-bit counter
Input Signal Trigger Level
(typical)
Voltage Range
Resolution, levels < ± 5V
Resolution, levels > ± 5V
Hysteresis, levels < ± 5V
Hysteresis, levels > ± 5V
Slope
− 25 V to + 25 V
40 mV
200 mV
0 to 250 mV
0 to 1.25 mV
Programmable, positive or negative
Input Signal Timing
Minimum pulse width
Maximum pulse rate
Trigger holdoff
5 µ s
100 kHz
1 to 65536 clock periods
Input Impedance
20 k Ω (typical)
Option AYF Tachometer Input
Specifications
8 of 12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com