HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 64 / 458

-48
6. Remove the material carriers by first pushing them in to unlatch and then
pulling them outwards.
7. Place the carrier on a flat stable surface.
8. Open the carrier.
9. Rotate the spool to rewind the material, leaving 2 inches (50mm)
remaining at the material guide. See Figure 28.
Figure 28: Rewinding the material spool
10. Using a cutters, cut the excess 2 inches (50mm) of material from the
material guide. leaving a blunt end.
11. Replace the material spool.
12. Close and latch the carrier.
13. Once the material carriers have been replaced press
Load...
14. Select
Load Model, Load Support
or
Load both
.
15. After material has been loaded to the head press
Done...
Replacing material for dual material
bays
1. From the display panel press
Material...
The display will show
Add/
Remove
and
S1(remaining%)
,
S2(remaining%)
and
M1, M2
(remaining%)
. Asterisks will mark the currently active material bays (the
material bays that are currently loaded to the head).
2. Press
Unload...
3. Press
Unload both
,
Unload Model
or
Unload Support
.
4. The printer will now unload material from the head. When the material
has unloaded, you will need to replace the material carriers.
5. Open the material bay doors by gently pressing in to release and pull-
ing outwards.
6. Remove the material carriers by first pushing them in to unlatch and then
pulling them outwards.
CAUTION: Do not push the material through the material guide
back into the carrier, doing so can cause material to break or
become tangled.