HP DESIGNJET 3D, Руководство по обслуживанию

Страница: 378 / 458

-362
Figure 357: Measuring distance from outside edges of A and B
11. Next measure and record the distance from the outside edges of circle B
and C, see Figure 358 Ensure that the caliper is not seated on the small
bump of circle C.
Figure 358: Measuring distance from outside edges of B and C
12. Add the lengths derived from steps 5 and 6 (A-B and B-C) and then sub-
tract the width of circle B. Record this total as “GFront”
13. Measure and record the distance from the outside edges of circles E and
F. Ensure the caliper is not seated on the small bump of circle E. See Fig-
ure 378
Figure 359: Measuring distances from outside edges of C and F