HP StorageWorks Disk System 2120
10
SCSI ID Switch
The SCSI ID switch sets the address for the disk drives.
There are three possible settings for the SCSI address switch: A, B, and C. Each
setting assigns a different
set
of addresses to the disk modules installed in the disk
system. For SCSI address switch setting A, the addresses for the installed disk
modules are (from left to right, looking at the disk system from the front) 0, 2, 4, and
6. For SCSI address switch setting B, the addresses for the installed disk modules are
8, 10, 12, and 14. For SCSI address switch setting C, the addresses for the installed
disk modules are 9, 11, 13, and 15. See Figure 5, below.
SCSI address 7 is reserved for use by the host bus adapter.
FIGURE 5
SCSI ID Switch Settings
Note
The disk system requires a terminator when it is installed at the end
of the SCSI bus.
0
8
9
2
10
11
4
12
13
6
14
15
A
B
C
SCSI
Address
Switch
Setting
Disk Module SCSI Addresses (Viewed from front of storage enclosure)
C
B
A
