4
Tools Required
The following tools are needed for assembly/disassembly of the autochanger:
• Torx driver with the following bits: T-10, T-20
Kit Contents
Check the conversion kit to make sure you have the following parts:
• 2 - 4X drives — # C1113-60x00
• 1 - drive interface cable — # C1107-60x63
• 1 - drive power cable — # C1107-60x55
• 1 - drive SCSI cable — # C1107-60x46
• 2 - drive interface cable clamps — # 1400-0611
• 1 - capacitive load (terminator) - C1108-61600
• 1 - drive bracket air seal — # C1107-80604
• 10 - M3x6 T10 screws — # 0515-2382
• 2 - product upgrade label sheets (Upgrade to: ) — # 5181-9902
• 1 - these instructions
Note
This document is not necessarily revised as each part number
is revised.
In the above list, an “x” is placed in “service” part numbers
(parts orderable from Support Materials Organization) to
designate that this digit increments when the part is revised.
This digit usually starts at “0” and increments up to “9.”
Knowing this should help you locate the correct part at SMO.
For any other parts that may be missing from this kit, contact
your supplier.
Содержание C1107 Series
Страница 2: ... Hewlett Packard Company 1998 ...
Страница 7: ...7 Figure 1 Drive locations in 8 10 and 12 drive upgrades ...