HP BCDVideo BCD108, Руководство пользователя

Страница: 51 / 162

Hardware options installation 51
o
Installing an NVDIMM (on page 52 ) — For installing NVDIMM-Ns with an HPE Smart Storage
Battery
DIMM handling guidelines
CAUTION: Failure to properly handle DIMMs can cause damage to DIMM components and
the system board connector.
When handling a DIMM, observe the following guidelines:
•
Avoid electrostatic discharge (on page 139 ).
•
Always hold DIMMs by the side edges only.
•
Avoid touching the connectors on the bottom of the DIMM.
•
Never wrap your fingers around a DIMM.
•
Avoid touching the components on the sides of the DIMM.
•
Never bend or flex the DIMM.
When installing a DIMM, observe the following guidelines:
•
Before seating the DIMM, open the DIMM slot and align the DIMM with the slot.
•
To align and seat the DIMM, use two fingers to hold the DIMM along the side edges.
•
To seat the DIMM, use two fingers to apply gentle pressure along the top of the DIMM.
For more information, see the Hewlett Packard Enterprise website
(
http://www.hpe.com/support/DIMM-20070214-CN ).
Installing a DIMM
The server supports up to 24 DIMMs.
To install a DIMM:
1.
Power down the server (on page 21 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 21 ).
o
Remove the server from the rack (on page 22 ).
4.
Remove the access panel (on page 22 ).
5.
Remove the air baffle.
6.
Open the DIMM slot latches.