MF877-00 Page 3
Template Revision C, 30-July-2018
Copyright 2018 Hewlett Packard Enterprise Development LP
HPE instructions for this template are available at
1.Remove the two screws on the bracket at the position shown in the figure with the torque force
equipment(Type:DEC).
2.Put the unit onto the fixture,and remove the four screws from the die cast with torque force equipment(Type:TT10).
3.Remove the top cover.
4.Use electrostatic tweezers to remove the antenna cable from the PCBA board. Remove the four screws with torque
force equipment(Type:PH1).
5.Remove the antenna plate from the PCBA board. Please note that you should handle the edge of the antenna plate to
remove, don
’t touch the antenna module and terminal.
