HP Aruba 7010 Series, Руководство по установке, Страница: 14 / 28

14
| 7010 Controller
Aruba 7010 Series Controller
| Installation Guide
Mini USB Console Connector
The Aruba 7010 controller is equipped with one Mini USB (type B) connector that provides console access for direct
local access. See Figure 4 on page 10 . If both Mini USB and RJ-45 Console ports are connected, the Mini USB
connection takes precedence over the RJ-45 Console connection.
Mini USB Driver
To use the Mini USB console port, you must install the Aruba Mini USB driver on the computer that will manage your
controller. To download the driver, perform the following steps:
1. Go to
https://support.arubanetworks.com .
2. Click on the Tools & Resources tab.
3. Open the USB Console Driver folder.
4. Open the Mobility Controller and Mobility Access Switch folder.
5. Select the appropriate file for your application. The corresponding operating system is in the file name.
Console Port
Use the serial CONSOLE port to allow direct local management. See Figure 4 on page 10 . This port is a RJ-45 female
connector that accepts an RS-232 serial cable with a male connector.
Figure 5 Serial Console Port Pin-Out
The communication settings for the Console port is shown in the following table:
SPEED Interface Speed Green (Solid) 1000Mbps
Off 10/100Mbps
Table 10
Console Terminal Settings
Baud Rate Data Bits Parity Stop Bits Flow Control
9600 8 None 1 None
!
CAUTION
The CONSOLE port is compatible only with RS-232 devices. Non-RS-232 devices, such as APs, are not
supported.
Table 9
10/100/1000BASE-T (RJ-45) Management Port (Continued)
LED Function Indicator Status
Serial
Console Port
1
2
3
4
5
6
7
8
TxD
GND
RxD
RJ-45 Female
Pin-Out
Direction
Input
Output
GND