HP Apollo 2000 System, Руководство пользователя, Страница: 93 / 203

9. Install the bayonet board bracket and bayonet board assembly .
10. If installing a host bus adapter or Smart Array controller, install it into the riser cage .
11. Do one of the following:
• Connect the B140i SATA cable to the system board.
• Connect all necessary internal cables to the storage controller.
For internal cabling information, see " SATA and Mini-SAS cabling ."
12. Route and secure the cables under the thin plastic cover along the side of the node tray.
13. Install any removed PCI riser cage assemblies .
14. Install the node into the chassis .
15. Connect all peripheral cables to the node.
16. Power up the node .
PCI riser cage assembly options
For more information on the riser board slot specifications, see " PCIe riser board slot definitions ."
For more information about product features, specifications, options, configurations, and compatibility, see the
product QuickSpecs on the
Hewlett Packard Enterprise website .
Single-slot left PCI riser cage assembly option
Procedure
1. Power down the node .
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis .
4. Place the node on a flat, level surface.
5. Remove the rear I/O blanks .
PCI riser cage assembly options 93