HP Apollo 2000 System, Руководство пользователя

Страница: 100 / 203

10. Do one of the following:
• Install the 1U left rear I/O blank .
• Install the single-slot left PCI riser cage assembly .
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all PCI riser
cages or rear I/O blanks are installed, and do not operate the node unless all PCI slots have
either an expansion slot cover or an expansion board installed.
IMPORTANT:
If the PCIe riser cage assembly is not seated properly, then the server does not power up.
11. Install the node into the chassis .
12. Connect all peripheral cables to the node.
13. Power up the node .
FlexibleLOM 2U node riser cage assembly option
Procedure
1. Power down the node .
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis .
4. Place the node on a flat, level surface.
5. Remove the 2U rear I/O blank .
6. Remove the PCI blank.
100 FlexibleLOM 2U node riser cage assembly option