HP 828689-002, Руководство пользователя, Страница: 34 / 74

Hardware options installation 34
6.
Install the TPM security rivet by pressing the rivet firmly into the system board.
7.
Install the server (" Installing a server " on page 16 ).
8.
Power up the server (on page 12 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker setup, and can be saved and printed after
BitLocker is enabled. When using BitLocker, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
•
Always store the recovery key/password in multiple locations.
•
Always store copies of the recovery key/password away from the server.
•
Do not save the recovery key/password on the encrypted hard drive.
Enabling the Trusted Platform Module
CAUTION: When a TPM is installed and enabled on the server, data access is locked if you
fail to follow the proper procedures for updating the system or option firmware, replacing the
system board, replacing a hard drive, or modifying OS application TPM settings.
1.
During the server startup sequence, press the F9 key to access System Utilities.
2.
From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU)
>
Server Security
.
3.
Select Trusted Platform Module Options , and press the Enter key .
4.
To set the TPM operational state:
o
If TPM 1.2 is installed, then select No Action, Enable, Disable, or Clear .
o
If TPM 2.0 is installed, then select
No Action
or
Clear
.
5.
Select Visible to set the TPM Visibility, if necessary.
6.
Press the F10 key to save your selection.
7.
When prompted to save the change in System Utilities, press the Y key.