HP 828689-002, Руководство пользователя

Страница: 28 / 74

Hardware options installation 28
CAUTION: To avoid damage to the hard drives, memory, and other system components, the
air baffle, drive blanks, and access panel must be installed when the server is powered up.
1.
Power down the server (on page 12 ).
2.
Remove the server from the chassis (on page 12 ).
3.
Open the DIMM slot latches.
4.
Install the DIMM.
5.
Install the server into the chassis (" Installing a server " on page 16 ).
6.
Power up the server (on page 12 ).
To configure the memory mode, use UEFI System Utilities (" HPE UEFI System Utilities " on page 43 ).
Hot-plug hard drive guidelines
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest bay number.
•
Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.