HP 780019-S01, Руководство по техническому обслуживанию и ремонту

Страница: 53 / 105

Removal and replacement procedures 53
7.
Remove the M.2 SSD enablement board.
To replace the component, reverse the removal procedure.
If you are not replacing the enablement board, install the screw and the PCIe blank into the PCIe riser
cage before installing the PCIe riser cage back into the server.
DIMMs
To remove the component:
1.
Power down the server (on page 16 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 17 ).
o
Remove the server from the rack (on page 17 ).
4.
Remove the access panel (" Access panel " on page 26 ).