RF Radiation Exposure Statement: This equipment complies with RF radiation exposure limits. This equipment should
be installed and operated with a minimum distance of 7.87 inches (20cm) between the radiator and your body for 2.4
GHz and 5 GHz operations. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclaration sur les limites d'exposition aux radiofréquences : cet équipement est conforme aux limites d'exposition
aux rayonnements radioélectriques spécifiées. Il doit être installé et utilisé à une distance minimale de 35 cm par
rapport à votre corps pour les fréquences de 2,4 et 5 GHz. Cet émetteur-récepteur ne doit pas être utilisé ou situé à
proximité d'autres antennes ou émetteurs-récepteurs.
Portable RF communications equipment should be used no closer than 30 cm (12 inches) to any part of the access
point. Otherwise, degradation of the performance of this equipment could result.
Access Point Installation
All Aruba access points should be professionally installed by an Aruba-Certified Mobility Professional (ACMP). The
installer is responsible for ensuring that grounding is available and meets applicable national and electrical codes.
Failure to properly install this product may result in physical injury and/or damage to property.
Tous les points d'accès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier doit
s'assurer que l'appareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques
nationaux en vigueur. Le fait de ne pas installer correctement ce produit peut entraîner des blessures corporelles et /
ou des dommages matériels.
For indoor use only. The access point, AC adapter, and all connected cables are not to be installed outdoors. This
stationary device is intended for stationary use in partly temperature controlled weather-protected environments
(class 3.2 per ETSI 300 019).
Software
Aruba 650 Seriesrequires ArubaOS or Aruba Instant8.10.0.0 or later. For instructions on choosing operating
modes and initial software configuration, refer to the
.
Aruba access points are classified as radio transmission devices, and are subject to government regulations of the
host country. The network administrator(s) is/are responsible for ensuring that configuration and operation of this
equipment is in compliance with their country’s regulations. For a complete list of approved channels in your country,
refer to the Aruba Downloadable Regulatory Table at
https://www.arubanetworks.com/techdocs/DRT/Default.htm
Verifying Post-Installation Connectivity
The integrated LEDs on the access point can be used to verify that the access point is receiving power and
initializing successfully (see Table 1 and Table 2). Refer to the
AP Software Quick Start Guide
for further
details on verifying post-installation network connectivity.
Ethernet
l
E0: 100/1000/2500/5000 Base-T auto-sensing Ethernet RJ-45 Interfaces
l
E1: 100/1000/2500/5000 Base-T auto-sensing Ethernet RJ-45 Interfaces
Power
l
Power over Ethernet (IEEE 802.3at and 802.3bt compliant)
l
12V DC power interface, support powering through AC-to-DC power adapter
l
Maximum power consumption: Refer to datasheet
Rev 01 | March 2022
|
7
