
10
CAUTION:
When removing the OAP card, note the following guidelines:
Do not touch the components on the surface of the OAP card.
Do not apply excessive force while removing the OAP card.
If you do not install a new OAP card in the slot, install a blank panel to
prevent dust from entering the switch and ensure normal ventilation in the
switch.
Connecting the management Ethernet port
cable
Follow these steps to connect the management Ethernet port cable:
Step1
Connect the management Ethernet port to the terminal.
•
To connect the management Ethernet port of an OAP card to the Ethernet
port of a PC or router, use a crossover cable.
•
To connect the management Ethernet port of an OAP card to the Ethernet
port of a hub or switch, use a straight-through cable.
Step2
After the OAP card is powered on, check the management Ethernet
port status LED on the front panel of the OAP card. If the LED is on, a
link is present; if the LED is off, no link is present, and you need to check
the line.
Verifying the installation
After the OAP card is installed, you can check the status of the LEDs on
the front panel of the OAP card to verify the operation state of the OAP
card. If the OAP card works abnormally, check whether the OAP card is
correctly installed.