HP 5243, Инструкция по установке и эксплуатации

Страница: 14 / 38

Installing and Configuring the Tape Drive for the
NonStop S-Series Server
5243 Tape Drive Installation and User’s Guide — 542758-003
2 -2
Installation
4. Connect one end of the SCSI cable to the top SCSI port at the rear of the tape
drive. See Figure 2-2 for the location.
5. Hand tighten the screws to secure the cable to the unit.
6. Connect the opposite end of the SCSI cable to the NonStop S-series server.
The tape drive can connect to the
ServerNet/DA
,
IOMF2 CRU, or PMF CRU
on
the NonStop S-series server.
You can use any of the SCSI cables listed in Table 2-1 .
7. Place a terminator on the bottom SCSI port of the tape drive.
8. Check that the power button on the front of the tape drive is off.
9. Connect the power cord to the AC power receptacle on the rear of the tape drive.
Check that the power cord is fully seated.
Note. The tape drive’s SCSI ID comes preconfigured to SCSI ID 5. If you need to change
the SCSI ID, use a screwdriver. Do not use a lead pencil.
Figure 2-2. Rear View of Tape Drive
Table 2-1. SCSI Cables
Model Number Description
519-003W 3 meter copper SCSI cable
519-015W 15 meter copper SCSI cable
519-020W 20 meter copper SCSI cable
519-023W 23 meter copper SCSI cable
AC Power Receptacle Fan SCSI Ports SCSI ID