HP 5130 EI Switch Series, Руководство по настройке, Страница: 69 / 171

63
RRPP configuration examples
Single ring configuration example
Network requirements
As shown in Figure 19 :
•
Device A, Device B, Device C, and Device D form RRPP domain 1. Specify the primary control VLAN
of RRPP domain 1 as VLAN 4092. Specify the protected VLANs of RRPP domain 1 as VLANs 1
through 30.
•
Device A, Device B, Device C, and Device D form primary ring 1.
•
Specify Device A as the master node of primary ring 1, GigabitEthernet 1/0/1 as the primary port,
and GigabitEthernet 1/0/2 as the secondary port.
•
Specify Device B, Device C, and Device D as the transit nodes of primary ring 1. Specify
GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the secondary port on
Device B, Device C, and Device D.
Figure 19 Network diagram
Configuration procedure
1. Configure Device A:
# Create VLANs 1 through 30.
<DeviceA> system-view
[DeviceA] vlan 1 to 30
# Map these VLANs to MSTI 1.
[DeviceA] stp region-configuration
[DeviceA-mst-region] instance 1 vlan 1 to 30
# Activate the MST region configuration.
[DeviceA-mst-region] active region-configuration
[DeviceA-mst-region] quit
# Set the physical state change suppression interval to 0 seconds on GigabitEthernet 1/0/1.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] link-delay 0