HP 16610A, Руководство пользователя

Страница: 82 / 171

80
Chapter 4: Configuring the Emulation Probe/Module
Entering Emulation Probe/Module Commands
proc - Set type of target processor
procck - Set clock speed of target processor
dprocck - Display default clock speed of target processor
dbgconfig - Define debug pin connection (MPC555 only)
rstword - Reset configuration word source (MPC505/509 only)
bnchardbrk - Set BNC break type
breakin - BNC break in control
rrt
- Set restriction to real time runs
trigout - Trigger out control
M>
To use a debugger interface
Because the HP emulation probe/module can be used with several
third-party debuggers, specific details for sending the configuration
commands from the debugger to the emulation module cannot be given
here. However, all debuggers should provide a way of directly entering
terminal mode commands to the emulation module. Ideally, you would
create a file that contains the modified configuration entries to be sent
to the emulation module at the beginning of each debugger session.
See Also
Information about specific debuggers in the “Using Debuggers” chapter
on page 89.
Your debugger manual.