freehub bodyr
The freehub body can be replaced. Use
only the original GO SWISSDRIVE repla-
cement part.Tighten the freewheel body
with max. 8 Nm.
Juli 2018
c.The wiring harness is to be installed at
an angle so that he can later be attached
in a
bow to the seat stay.
d. If a disc brake is fitted insert the brake
disc carefully in the brake calliper.
e. Now tighten the M10 axle nuts
evenly. Pay attention to the
Washers between frame and
Axle nuts.These must rest flat.
2. If a rim brake is fitted,
reattach the brake cable and
check if the rear wheel runs freely.
Also read the instructions in your bike
manual.
3. Check the display whether the system
is switched off. Connect the motor with
cable plug to the cable harness.
Danger!
When using a disc brake,
pull the brake lever until a solid pressure
point is reached. It must not be possible to
pull the brake lever all the way to the hand-
lebars.
Danger!
Use only self-locking
M10x1 nuts. Original replacement nuts are
available from your dealer as
GO SWISSDRVE spare parts.
Danger!
Always tighten the axle
nuts with a torque wrench and 45 Nm.
Attention!
Pay attention to the
reverse polarity protection (geometric align-
ment) on the plug. Insert the plugs slowly
and sensitively and under no circumstances
by force.
Also pay attention to the seal on the plug.
When plugged in, this must be located
exactly in the socket provided for this pur-
pose in order to guarantee tightness.
Attention!
Make sure that the
cables are not under tension and are not cut
by cable ties when mounting.