Safety Information
Use this fireplace only as described. Any other use may cause fire or injury.
WARNINGS
• The heater operation can cause the heat exhaust vent and metal frame on the front of the fireplace to get hot. Never leave the
fireplace unattended while in operation.
• To avoid contact-type burns, always keep children away from the fireplace. Do not allow anyone to bump into or otherwise touch
the front of the fireplace while in operation or immediately after the heat operation has been shut off. Ensure that the area around
the exhaust vent and metal frame are cool to the touch.
• Keep decorations and other flammables away from the fireplace.
• Do not store or use gasoline or other flammable liquids or vapors in the vicinity of the fireplace.
CAUTION:
• For indoor use only.
• DO NOT operate the fireplace with a damaged cord or plug or after the heater malfunctions.
• To disconnect, turn all controls to the OFF position, then remove plug from outlet.
• If possible, ALWAYS unplug the fireplace when not in use.
• The fireplace must be connected to an electrical outlet that is grounded in accordance with local codes.
• To prevent a possible fire, DO NOT block any air intakes or exhaust in any manner.
• ALWAYS plug the fireplace directly into a wall outlet. NEVER use an extension cord or power strip.
• Discontinue use if the cord or plug gets hot.
• DO NOT place any objects on top of air intake vents as this will cause the unit to overheat and can cause a fire.
• The fireplace is not to be used for an actual fire.
Reference the label attached to the fireplace cord and the back of the fireplace unit for additional important safety information.
Troubleshooting
Problems
Possible Causes
Solutions
1. No power, logs do not
glow.
1. The fireplace does not
have power.
2. “E1” is displayed on
control panel.
2. The overheat protection
device has been
engaged.
3. “E2” is displaced on
control panel.
3. The ambient room
temperature has been
reached.
4. “E3” is displayed on
control panel.
4. Child lock function is
activated.
5. Fan motor continues to
blow after fireplace is
powered off.
5. Normal operation.
1. Check that the fireplace is plugged into a
standard 120 volt outlet. Then make sure
power is at “ON” position.
2. Unplug fireplace, wait 10 minutes, then the
sensor will reset. Plug the fireplace back in.
3. Unplug fireplace, wait 10 minutes, then the
sensor will reset. Plug the fireplace back in.
4. To inactivate the Child Lock function, see the
Child Lock instructions.
5. This is a standard feature; the blower runs
for an additional 20 seconds.
497227-r1
11/19
www.howardmiller.com
