Hougen 925102, Руководство оператора

Страница: 3 / 27

UNPACKING YOUR NEW MAGNETIC DRILL
1 .
Open shipping carton and remove the literature and
hardware packages.
2. Read and Follow All Instructions before attempting
to operate your new Magnetic Drill.
3.
Complete and mail the Product Registration Card now.
It is important that Hougen Manufacturing, Inc. have a
record of product ownership.
4. Open hardware package and check contents.
10565 1/8” Hex wrench for Gib Adjustment
04558 Feed handles (3)
04532 Feed handle knobs (3)
90724 Safety chain
02635 3/16” Hex wrench for cutter installation
13013 5/32” Hex wrench
5. Using the handle of Magnetic Drill, lift unit out of the
shipping case.
6. Remove all packing and securing material from the drill
unit.
7. Screw the three Knobs (04532) into the three
Feed Handles (04558) and then screw Handles
into the Hub Assembly (19030). Do not overtighten
or may strip the knobs.
8. Your Magnetic Drill was factory adjusted prior to
shipping. Check to make sure that all gib
adjustment screws, motor mount screws, front
support bracket screws, and magnet mounting
screws are snug and have not vibrated loose in
transit.
9. Your new Magnetic Drill comes complete with
arbor mounted. The 3/4” diameter arbor bore
fi ts all 3/4”-shank “12,000-Series” Hougen
Cutters.
Reread Safety Warnings listed in the Operator’s
Manual and on the drill unit to avoid injury. Follow
operating procedures.
3
Always wear eye protection while
using cutting tools, or in the vicin-
ity of cutting.
CAUTION! The slug is ejected
at the end of the cut. Do not aim
cutter or arbor so that ejected
slug may hit someone around, or
below you.
CAUTION! Cutters are sharp.
Wear gloves when installing or
removing cutter from arbor. Do
not grab a rotating cutter.
CAUTION! To prevent electric
shock, do not use power tools
near wet areas, or where power
tool may become wet.
SAFETY FIRST
0925102, 202 & 302 PARTS LIST 13
0925104, 204 & 304 DRILL BREAKDOWN 14
0925104, 204 & 304 PARTS LIST 15
MAGNET BREAKDOWNS 16
ARBOR ASSEMBLY BREAKDOWN 17
120v CONTROL PANEL ASSEMBLY 18
230v CONTROL PANEL ASSEMBLY 19
120v MOTOR SLIDE ASSEMBLY 20-21
MOTOR BREAKDOWNS 22-25
MAINTENANCE & TIPS 26-27
WARRANTY REPAIR CENTERS 28
WELCOME TO HOUGEN 2
UNPACKING YOUR DRILL 3
SAFETY INSTRUCTIONS 4 - 5
SAFETY SWITCH INDICATOR LIGHT 5
CONTROL PANEL 6
OPERATING INSTRUCTIONS 7
INSTALLING HOUGEN CUTTERS 8
CUTTING FLUID RESERVOIR 8
SWIVEL BASE INSTRUCTIONS 9
ARBOR & GIBS ADJUSTMENT 10
0925102, 202 & 302 DRILL BREAKDOWN 12
INDEX