HZE-1500W Installation
4
WALL MOUNTING BRACKET
The heater does NOT include hardware for attaching the mounting bracket
to the wall.
1.
Use the four Phillips head screws removed above to attach the junction
box cover. (Figure 1)
2.
Remove the mounting bracket from the hardware bag.
(Figure 2)
3.
Determine an appropriate mounting location according
to all specified clearances, and be sure your mounting
hardware will fasten the unit securely to the wall. Place
your mounting hardware through the holes in the bracket
to secure it to the wall.
4.
Lift the heater up to the bracket and secure with the two
bolts, washers and nuts from the hardware bag.
Figure 2 - Holes in mounting bracket.
The bracket is adjustable both up and down and from side to side.
When adjusting up and down, be sure to loosen the allen screws (using the
allen wrench provided) before moving the heater and then tighten them just
enough to hold the unit in place. (Figure 3)
Overtightening can bend the
frame and damage the unit.
Use caution when adjusting the heater from side to side. Be sure the bolts and
nuts pictured above (which attach the junction box to the mounting bracket)
are not too tight. (Figure 2)
Figure 3 - Loosen for
up/down adjustment.
** The power cord MUST be attached to the heater BEFORE the unit is secured to the wall. **
Remove the four Phillips head screws that
hold the junction box cover in place.
Follow the Wiring Instructions on page 6,
then return to this page.
HZE-1500W Wiring Schematic
(see page 6 for instructions)
Figure 1
5.
Plug the heater in and test operation.
