Hotronix Sport Ball Heat Press Manual / 2016-09-28a / pg 4 of 4
Printing with your Ball Press
1. Fully inflate Ball and position on
Ball Mount. Turn on press and enter
recommended settings:
8 sec @ 235°F (110°C)
WARNING:
Printing above 250°F will
scorch most balls.
2. Lower the handle until the heater
touches the ball, then unlock the Ball
Mount by rotating the Adjustment
Handle counter-clockwise.
3. Using the handle to raise or lower
the Ball Mount will adjust print
pressure. Most balls will print well
with about 2in of space between the
Electromagnet and the steel plate on
the handle.
4. Align the transfer material on the
ball to be printed.
WARNING
: Transfer material will not
adhere to stitched seams or recessed
features.
5. Lower and lock the handle to print.
The timer will count down and
automatically raise the heater when
the press cycle is complete. When
the handle lifts, the timer will re-set
and you are ready for the next
application.
6. Pebbled products (e.g. basketballs
and footballs) require a secondary
press using Flex Application Pad.
All copyright, trademarks and all other intellectual property rights in this document and its content (including without
limitation the design, text, graphics and all equipment and patents described within the document) are owned by or
licensed to Hotronix, Inc. or otherwise used by Hotronix, Inc. as permitted by law.
