Hotpoint WLW3000R, Инструкция по использованию и уходу

Страница: 5 / 24

Wash Water Temperature Selection
●
For hot water wash, set Cycle Selector
RINSE WATER TEMPERATURE WILL
to HOT WASH.
ALWAYS BE COLD.
●
For cold water wash, set Cycle Selector
to COLD WASH.
Starting or Choosing the Cycle
●
Pull Cycle Selector knob out to start the cycle.
If you wish to change cycle setting after washer has
START ,
started, push Cycle Selector knob in to stop washer
and reset to the new position. Setting can be changed
at any time during the cycle.
STOP
How to Soak in Your Washer
Allow the washer to fill and agitate for a few minutes to dissolve the
soaking agent. Then push in the Cycle Selector knob to stop the washer
(keep lid closed) and allow to soak for as long as desired.
After desired soak period, pull out Cycle Selector knob to complete cycle.
What Happens in Each Setting (Approximate Minutes)
I
NOTES:
●
Total time includes pauses between each phase of
the cycle.
●
Total time does include water fill times. Fill times
vary depending on household water pressure and your
selected water level.
ENERGY-SAVING
If your clothes and household items don’t look clean
●
If you notice that soil has accumulated after several
and fresh after washing, you will probably rewash
consecutive washings, use Hot Wash occasionally, if
them... and that means you’ll waste energy. Remember
safe for fabrics.
to sort your clothes carefully, load them properly, and
use enough detergent.
●
Try to wash less often. Save articles of the same type
of fabric until you have a full load.
●
Wash in off-peak utility hours. Your local utility can
tell you which are the off-peak hours.
5