11
If Something Goes Wrong
Problem
Possible Causes
What to Do
Washer is unplugged
•
Make sure cord is plugged securely into a
working outlet.
Water supply is turned off
•
Turn both hot and cold taps fully on.
Controls are not set properly
•
Check controls and make sure Cycle knob
is pulled out to ON position.
Lid is open
•
Close lid and pull Cycle knob out to ON
position.
Circuit breaker/fuse is
•
Check house circuit breakers/fuses. Replace
tripped/blown
fuses or reset breaker. Washer should have
separate outlet.
Washer Won’t Operate
Drain hose is kinked or
•
Straighten drain hose and make sure
improperly connected
washer is not sitting on it.
•
Top of drain outlet should be less than
1m (3 ft.) above floor.
Water Won’t Drain
Control is not set properly
•
Check water temperature control and adjust.
Water supply is turned off
•
Turn both hot and cold taps fully on and
or improperly connected
make sure hoses are connected to correct
taps.
Water valve screens are
•
Turn off the water source and remove the
stopped up
water connection hoses from the upper back
of the washer. Use a brush or toothpick to
clean the screens in the machine. Reconnect
the hoses and turn the water source back on.
House water heater is not set
•
Make sure house water heater is delivering
properly
water at 48°C.–65°C. (120°F.–150°F.).
Water Temperature
is Incorrect
