3
Installation
W
arnings
Maintenance
and Care
Description
Star
t and
Pr
ogrammes
Laundr
y
T
roub
leshooting
Pr
oduct data
Ser
vice
GB
Installation
!
Do not use extension cords.
!
The power cord must not be bent or
squashed.
!
The power cord should be regularly
checked. If the supply cord is damaged, it
must be replaced by the manufacturer, its
service agent or similarly qualified persons
in order to avoid a hazard. New or longer
power cords are supplied at an extra
charge by authorised dealers..
!
The manufacturer denies any responsibility
should any of these rules not be followed.
!
If in doubt about any of the above consult
a qualified electrician.
Levelling your dryer
The dryer must be installed level for correct operation.
When you have installed
your dryer in its final
location check that it is
level first side to side,
then front to back.
If the dryer is not level, use a
wooden block to support it while
adjusting the two front legs up or
down, until your dryer is level.
Before you start using your dryer
Once you have installed your dryer and before you
use it, clean the inside of the drum to remove any
dust that could have accumulated during transport.
Maximum load
Natural fibres : 7 kg
Open window venting
The end of the tube
should be directed
downwards, to prevent
warm moist air from
condensing in the room or
in the dryer.
!
Ensure that the dryer is adequately ventilated and
that the end of the vent tube is not directed towards
the air intake duct.
!
The vent tube must always be fitted for optimum
performance.
!
Make sure that the vent tube and air intake vents are
not obstructed or blocked.
!
The dryer must not recycle exhaust air.
!
Misusing a tumble dryer may create a fire hazard.
!
Do not discharge exhaust air into a flue which is
used for exhaust fumes from other appliances that
burn gas or other fuels.
!
Do not discharge exhaust air into an extraction
system or any duct with an extractor fan. This will
affect the way the thermal controls operate and can
result in a fire hazard.
Electrical connections
Make sure of the following before you
insert the plug into the the electrical
socket:
●
Make sure your hands are dry.
●
The socket must have an earth connection.
●
The socket must be able to sustain the
machines maximum power, which is
indicated on the rating label (
see Dryer
Description
).
●
Power voltage must be within the values
indicated on the rating label (
see Dryer
Description
).
●
The socket must be compatible with the
dryers plug. Should this not be the case,
replace the plug or the socket.
!
The dryer must not be installed outdoors,
even if the space is sheltered. It can be
very dangerous if it is exposed to rain or
storms.
!
Once installed, the dryers electrical wire
and plug must be within easy reach.
