6
GB
Start and Programmes
Choosing a programme
1.
Plug the dryer into the electrical socket.
2.
Sort your laundry according to fabric type (
see
Laundry
).
3.
Open the door and make sure the filter is clean
and in place (
see Maintenance
).
4.
Load the machine and make sure items are not in
the way of the door seal. Close the door.
5.
If none of the lights are on: Press the ON/OFF
button .
6.
Choose a programme by checking the Programmes
Guide (
see Programmes
) as well as the indications
for each type of fabric (
see Laundry
).
- Select a programme by rotating the
PROGRAMMES knob.
7.
Set a delay time and other options if necessary.
8.
The START/PAUSE light is flashing green:
- press the START/PAUSE button to begin.
The green light stops flashing.
During the drying programme, you can check on
your laundry and take out items that are dry
Shirts Light Dry
High heat option
●
This is a programme for shirts made from cotton.
●
It can be used for load sizes up to 3kg (approximately 10 shirts).
●
This programme will take about 60 minutes, but may take longer depending on the size of the load and the spin
speed used in your washer.
Low heat option
●
This is a programme for shirts made from synthetic materials or a mixture of natural and synthetic materials, such
as polyester and cotton.
●
It can be used for load sizes up to 3kg (approximately 14 shirts).
●
This programme will take about 55 minutes, but may take longer depending on the size of the load and the spin
speed used in your washer.
Shirts dried using this programme are usually ready to put away, the edges or seams may be slightly damp. If this is
the case, try turning the shirts inside out and running the programme again for a short period.
Jeans
●
This is a programme for jeans made from denim cotton. Before drying your jeans turn the front pockets inside out.
●
It can be used for load sizes up to 3kg (approximately 4 pairs).
●
Do not mix dark and light coloured items.
●
It can also be used on other garments made from the same material, such as jackets.
●
This programme will take about 85 minutes, but may take longer depending on the size of the load and the spin
speed used in your washer.
●
Loads dried using this programme are usually ready to wear, the edges or seams may be slightly damp. If this is
the case, try turning the jeans inside out and running the programme again for a short period.
!
We do not recommend that you use this programme if your jeans have elastic waist bands, studs or embroidery.
Note:
This tumble dryer, in compliance with new energy saving regulations, is fitted with an automatic standby system
which is enabled after about 30 minutes if no activity is detected. Press the ON/OFF button briefly and wait for the
dryer to reactivate.
while others continue drying. When you close
the door again, press the START/PAUSE button in
order to resume drying.
(
When the door is opened the START/PAUSE light
will flash Amber, after the door is closed and the
START/PAUSE button pressed, the START/PAUSE
light will stop flashing and show green.
)
Note:
During the Post Care phase this light
flashes Amber.
9.
At the end of the drying cycle the End light comes
on and either :
-
The buzzer will beep 3 times to let you know
that your programme is complete. (
Note
: If
the SOUND option was selected the buzzer
beeps 3 times every 30 seconds for 5
minutes).
or - If you have selected the Crease Care option
and you do not take the items out immediately,
the items will tumble occasionally for 10
hours or until you open the door, the buzzer
will then beep 3 times to confirm the
programme is completed.
10. Open the door, take the laundry out, clean the filter
and replace it (
see Maintenance
).
11. Unplug the dryer.
Содержание TVEL 75 Experience
Страница 18: ...18...
