15
Impor
tant
Inf
ormation
Installation
Description
Star
t and
Pr
ogrammes
Laundr
y
W
arnings and
Sug
g
estions
Maintenance
and Care
Ser
vice
T
roub
leshooting
GB
Troubleshooting
Problem:
The tumble dryer won’t start.
Drying cycle will not begin.
Its taking a long time to dry.
Programme finishes and
clothes are damper than
expected.
The ON/OFF light flashes to
indicate a fault.
Possible causes / Solution:
●
The plug is not plugged into the socket, or not making contact.
●
There has been a power failure.
●
The fuse has blown. Try to plug another appliance into the socket.
●
You are using an extension cord? Try to plug the dryer’s power cord
directly into the socket.
●
The door is not closed securely?
●
The PROGRAMMES knob has not been set properly (
see Start and
Programmes
).
●
The START button has not been pressed (
see Start and Programmes
).
●
You have set a delayed time (
see Start and Programmes
).
●
The filter has not been cleaned (
see Maintenance
).
●
The correct programme has not been selected for the load (
see Start
and Programmes
).
●
The flexible vent tube is obstructed (
see Installation
).
●
The air intake vent is obstructed (
see Installation
).
●
The permanent ventilation flap on the storm cover is obstructed (
see
Installation
).
●
The items were too wet (
see Laundry
).
●
The dryer was overloaded (
see Laundry
).
!
For safety the dryer has a maximum programme time of 3 hours. If an
automatic programme has not sensed the required final moisture in this time
the dryer will complete the programme and stop. Check the above points
and run the programme again, if the results are still damp, contact the
Service Centre (
see Service
).
●
Note down the other lights that are on and contact the Service Centre
(
see Service
).
One day your dryer seems not to be working. Before you call your Service Centre (
see Service
), go through the
following troubleshooting suggestions:
19509523801 TVAL 73 11/10/11 16:01 Page 15
