16
GB
Troubleshooting
Problem:
The tumble dryer won’t start.
Drying cycle will not begin.
Its taking a long time to dry.
The ‘water container full’ icon
is flashing and displayed
but the dryer has only been
running for a short period.
Empty water icon is on and
the water container is not full.
Programme finishes and
clothes are damper than
expected.
The display shows a fault
code F followed by one or two
numbers
Possible causes / Solution:
●
The plug is not plugged into the socket, or not making contact.
●
There has been a power failure.
●
The fuse has blown. Try to plug another appliance into the socket.
●
You are using an extension cord? Try to plug the dryer’s power cord
directly into the socket.
●
The door is not closed securely?
●
The PROGRAMMES knob has not been set properly (
see Start and
Programmes
).
●
The START/PAUSE button has not been pressed (
see Start and Programmes
).
●
You have set a delayed time (
see Start and Programmes
).
●
The filter has not been cleaned (
see Maintenance
).
●
The water container needs emptying... The ‘water container full’ icon
is flashing, the display shows and the ‘empty water’ icon is on
(
see Maintenance
).
●
The condenser needs cleaning? (
see Maintenance
).
●
The temperature setting is not ideal for the type of fabric you are drying
(
see Start and Programmes, and see Laundry
).
●
The correct drying time has not been selected for the load (
see Laundry
).
●
The air intake grille is obstructed (
see Installation, and see
Maintenance
).
●
The items were too wet (
see Laundry
).
●
The dryer was overloaded (
see Laundry
).
●
The water container was probably not emptied at the start of the
programme. Do not wait for the empty water signal, always check and
empty the container before starting a new drying programme (
see
Maintenance
).
●
This is normal. If the icon is on it is just a reminder to empty the container
(
see Start and Programmes
).
!
For safety the dryer has a maximum programme time of 4 hours. If an
automatic programme has not sensed the required final moisture in this time
the dryer will complete the programme and stop. Check the above points
and run the programme again, if the results are still damp, contact the
Service Centre (
see Service
).
●
If the display shows a fault:
- Turn off and remove the plug. Clean the filter and the condenser
unit (
see Maintenance
). Then replace the plug, turn on and start
another programme. If a fault is then displayed: Note down the
code and contact the Service Centre (
see Service
).
One day your dryer seems not to be working. Before you call your Service Centre (
see Service
), go through the
following troubleshooting suggestions:
Содержание TCFG 87C
Страница 18: ...18...
