11
GB
Choosing a programme
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type
(see Laundry)
.
3. Open the door and make sure the fi lter is clean and in
place and the water container is empty and in place
(see
Maintenance)
.
4. Load the machine and make sure items are not in the way
of the door seal. Close the door.
5. If the Display is not lit: Press the ON/OFF button
.
6. Press the Programmes Selection button that corresponds
with the type of fabric being dried by checking the
Programmes Table
(see Programmes)
as well as the
indications for each type of fabric
(see Laundry)
.
- if the
M
button is selected; steps 7 and 8 are not required
(see below).
7. Choose Timed Drying or Dryness Levels option:
- If Timed Drying press and release the Timed button until
the required time is displayed
.
or - To change from default dryness setting, press and
release the Dryness Levels button until required level is
indicated.
!
See Programmes Table, for more details: availability of
Dryness Levels, Timed Dry and Options.
8.Set a delay time and other options if necessary
(see The
Display)
.
9.Press the Start/Pause button
to begin. The display
will show the estimated time to end. During the drying
programme, you can check on your laundry and take out
items that are dry while others continue drying. When you
close the door again, press the Start/Pause button
in
order to resume drying.
If you open the door to check your laundry you will extend
the drying time as the heat pump compressor will not start for
5 minutes after you close the door and press the Start/Pause
button
(see The Controls).
My Cycle button:
First time you press this button the display will show
PRESS AND HOLD TO STORE
After selecting your favorite programme and options you can save these settings by pressing and holding in the My Cycle
button for at least 5 seconds, the top line will show a fl ashing
M
followed by the selected programme. The
buzzer will then beep and the second line of the display shows
MEMORY
The next time you need this programme press the
M
, button, then the Start/Pause button
(and this programme will run.
If you wish, you can change your stored favorite, by selecting a new programme and/or options and press and hold
in the
M
button (as above).
10. During the last few minutes of Drying Programmes,
before the programme is completed, the fi nal COOL
TUMBLE phase is entered (fabrics are cooled), this phase
should always be allowed to complete.
11. At the end of the drying cycle a message is displayed:
- if
END OF CYCLE, CLEAN FILTER AND EMPTY WATER BOTTLE
is shown, the buzzer will beep 3 times (
Note
: If the SOUND
option was selected the buzzer beeps 3 times every 30
seconds for 5 minutes).
- if
END OF CYCLE, CREASE CARE
is shown, Crease Care
option has been selected and if you do not remove the
laundry immediately, the dryer will tumble occasionally for 10
hours or until you open the door, the buzzer will beep 3 times
to confi rm the programme is completed.
12. Open the door, take the laundry out, clean the fi lter and
replace it. Empty the Water Container and replace it
(see
Maintenance).
13. Unplug the dryer.
Start and Programmes
