8
PREPARATION
Flooring Under the Range
Leveling the Range
Your range, like many other household items,
is heavy and can settle into soft floor coverings
such as cushioned vinyl or carpeting. When moving
the range on this type of flooring, it should be
installed on a 1/4-inch-thick sheet of plywood (or
similar material) as follows: When the floor covering
ends at the front of the range, the area that the range
will rest on should be built up with plywood to the
same level or higher than the floor covering. This will
allow the range to be moved for cleaning or servicing.
Leveling screws are located on each corner of the base
of the range. Remove the bottom drawer and you can
level the range on an uneven floor with the use of a
nutdriver.
To remove drawer, pull the drawer out all the way,
tilt up the front and take it out. To replace drawer,
insert the glides at the back of the drawer beyond stop
on the range glides. Lift the drawer if necessary to
insert easily. Let the front of the drawer down, then
push in to close.
One of the rear leveling screws will engage the Anti-
Tip device (allow for some side to side adjustment).
Allow a minimum clearance of 1/8
″
between the
range and the leveling screw that is to be installed into
the Anti-Tip device.
CLOCK AND TIMER
To Set the Clock
Push in and turn the clock knob clockwise to set the
correct time of day.
As you turn the knob you will notice that the timer
hand will turn as well. When you have set the correct
time of day, turn the timer hand to the OFF position.
12
9
3
6
0
10
20
30
1
2
3
4
OFF
To Set the Timer
Turn the timer hand counterclockwise without pushing in, until you have
reached the desired time you will need.
When the timer has counted down to “0” a buzzer will sound, alerting you
the time is up. Turn the timer hand to OFF.
NOTE: The timer is a reminder. It will not control the oven operations.
